Wholesale price of mortar delamination meter

Wholesale price of mortar delamination meter
Introduction to mortar delamination meter:
This instrument is mainly used to measure the water retention capacity of mortar during operation and parking, that is, the stability of the consistency.
The structure of the mortar delamination meter:
The inner diameter is cm, the upper section is cm high, the lower section is cm high, with a bottom, it is made of metal plate, and the upper and lower sections are connected with bolts.
Parameters of mortar delamination meter:
Inner diameter: .
Height of the previous section: .
Next section height: .
Maintenance of sand mortar delamination meter:
The instrument and equipment are not allowed to be dismantled, modified or disassembled for use at will. If it is necessary to develop new functions or modify and update, etc., it must be managed according to the hierarchical management authority and after completing the approval procedures. Implement again. Carry out regular maintenance and upkeep of the equipment and store it in a dry and ventilated place. If the equipment is not used for a long time, it should be powered on regularly to prevent moisture and mold from damaging the parts of the equipment. Establish a regular verification and calibration system for large-scale precision and valuable technical indicators to maintain appropriate technical indicators. Keep original records of use.
Purpose of the mortar delamination meter:
To measure the water retention capacity of the mortar delamination meter during operation and parking, that is, the stability of the consistency
Instrumental method for measuring the mortar delamination level:
Testing instruments: Mortar delamination meter, Mortar consistency meter
Others: Mixing pot, spatula, wooden hammer, etc.
Put the sample into the layered cylinder at one time. After it is full, use a wooden hammer to gently tap ~ times at four different places at roughly equal distances around the container. If the mortar sinks below the mouth of the cylinder, , you should add it at any time, then scrape off the excess mortar and smooth it. According to the method of measuring the fluidity of mortar, measure the sinking degree value of mortar in meters. After letting it stand, remove the mortar on top, pour out the remaining mortar, and mix it in a mixing pot. Then measure the sinking degree of the mortar according to the method of measuring fluidity. Result processing and accuracy requirements of the mortar delamination meter. The difference between the two sinking degrees is determined as the delamination degree of the mortar.
Mortar delamination tester test steps:
Conduct a consistency test on the mixed mortar first, and then fill the delamination cylinder with the same batch of mortar (or the mortar that has passed the consistency test and re-mix evenly). . After standing for a few minutes, take the mortar from the lower part of the container: remove the upper centimeter of mortar, then take out the bottom centimeter of mortar, mix it again, and then measure the mortar consistency. The difference in the consistency of the two mortars is the stratification degree of the mortar (cm). The degree of delamination of mortar shall be the arithmetic mean of the two test results.
Composition of mortar delamination tester:
It consists of three parts: test cone, container and support. The test cone is made of steel or copper. The height of the test cone is , and the diameter of the cone bottom is . The mass of the test cone together with the sliding rod should be , bracket and consistency display are made of three parts, made of cast iron, steel and other metals. Steel tamper: diameter, length, rounded ends. Stopwatch etc