How to install cycloidal reducer

> Installation of cycloidal reducer
The reducer should be fixed on a stable horizontal base when installed. When installing, pay attention to the oil in the oil drain tank to be drained smoothly, and the cooling air should also ensure smooth circulation. If there are gears and sprockets in the transmission parts, protective devices must be added for safety. If the output shaft bears a large radial load, a reinforced type must be selected.
The installation location must be such that packaging work or maintenance personnel can easily access the oil mark, oil drain plug, breather plug, etc. After the installation preparation work is completed, the accuracy of the installation position must be checked in sequence, and each fastener must be pressed reliably. .
During installation, be sure to ensure that the central axis of the transmission is in the middle, and the error cannot be large enough to compensate for the use of all couplings. The specific requirements should refer to the specific reducer model and requirements. If the installation is not accurate, its service life will be affected.
When installing the reducer, ensure that the center axis of the transmission is aligned, and the error shall not be greater than the compensation amount of the coupling used. For details, please refer to the specific reducer model and specific requirements. Good alignment can extend service life and achieve ideal transmission efficiency.
When installing the transmission parts on the output shaft of the reducer, it is strictly prohibited to use a hammer to hit it. The correct method is to use the assembly fixture and the internal thread of the shaft end to press the transmission parts in with bolts, otherwise the reducer may be damaged. Damage to internal parts. It is best not to use rigid fixed couplings, because improper installation of such couplings will cause unnecessary external loads, causing early damage to the bearings, and even causing the output shaft to break in severe cases.