Large fresh orange crushing press

YZJ：

1.5

The working process of the double screw press is that the conveying screw pushes the material entering the material box to the pressing screw. Through the reduction of the pitch of the pressing screw and the increase of the shaft diameter, the liquid contained in the material is expelled under the action of the resistance of the screen wall and the cone. The squeezed liquid flows out from the sieve hole and is concentrated in the juice receiving hopper. The squeezed pomace is discharged from the machine through the end of the sieve barrel and the cone. A spring is installed at the rear of the cone. The pre-tightening force of the spring is adjusted. The discharge resistance and the size of the slag outlet can be changed and the position can be used to adjust the dryness and wetness of the press. The press is a double screw with opposite rotation directions. The squeezing force on the material is large and uniform. The cone of the slag outlet is controlled and adjusted by a hydraulic cylinder. The oil pressure can change the pressure effect on the material and adjust the juice yield. This machine can also be used for solid-liquid separation of other materials. The effect will vary depending on the quality of the material. The feed box, screen drum and spiral of this machine are all made of high-quality acid and alkali-resistant stainless steel materials.
Advantages of the equipment
It has the characteristics of high strength, high load-bearing pressure, no deformation, no clogging, corrosion resistance, wear resistance, no slipping, convenient maintenance and long service life. This device can be used alone or multiple units can be used in series for better results. The slag outlet can change the pressure effect on the material by adjusting the spring pressure or oil pressure, thereby adjusting the dryness and wetness of the slag discharge. The squeezing effect will vary depending on the material.
Compared with decanter plate and frame filter press, vacuum suction filter, this equipment is particularly cost-effective and very effective. It is widely used in the solid-liquid separation of materials in the fruit wine and juice industry, as well as in other brewing, chemical, pharmaceutical, environmental protection and other industries. The moisture content of the material after machine pressing and dehydration is about