Hot-selling waterproof sealant cement expansion joint special PVC cement plastic ointment manufacturer is brilliant

Hot-selling waterproof sealant cement expansion joint special PVC clay plastic ointment manufacturer is brilliant, hot-selling waterproof sealant cement expansion joint special PVC clay plastic ointment manufacturer is brilliant, hot-selling waterproof sealant cement expansion joint special PVC clay The manufacturer of plastic ointment is brilliant, and the best-selling waterproof sealant cement for expansion joints is PVC cement. The plastic ointment manufacturer is brilliant, and the best-selling waterproof sealant cement is special PVC cement for expansion joints. The plastic ointment manufacturer is brilliant, and the best-selling waterproof sealant is The manufacturer of polyvinyl chloride glue and plastic ointment special for expansion joints is brilliant
Polyvinyl chloride glue is also known as: plastic glue, glue, plastic ointment, waterproof ointment, vinyl chloride caulking material
Polyvinyl chloride glue is A new type of building waterproofing material with the advantages of elasticity, strong adhesion, high heat resistance, good low temperature flexibility, slow aging, acid and alkali corrosion resistance, suitable for hot construction and can be used cold.
PVC cement caulking method
The PVC cement caulking method mainly requires the following four points:
PVC cement must be removed from the old cement concrete. Aged caulking materials and debris in the joints should be removed, and the joints should be kept dry and the moisture content should be less than 1.
. The new cement concrete should be cleaned after sawing the joints.
Cut the polyvinyl chloride clay into small pieces on the left and right and put it into the pot. Slowly heat up and stir continuously. When melting, the temperature should be controlled at ℃, and the maximum temperature should not exceed ℃. Keep the joints filled without bubbling and yellow smoke. Thick smoke. If the above phenomenon is found, anneal immediately and speed up the stirring. The melted caulking material can be used at any time and new material can be added for continuous operation. Polyvinyl chloride glue should avoid long-term heating to prevent the performance of the joint filler from changing. The melted joint material should be poured into the joint immediately with a pot. The joint material should be flush with the road surface. The excess material tip should be removed with a shovel to maintain driving comfort.
After each shutdown, the caulking material adhered to the pot should be removed cleanly so as not to affect the quality of the new caulking material. Only in this way can the effect be excellent.
/3/ PVC clay standards