Schneider 3KW servo motor dedicated high-precision VGM reducer

产地：

台湾

型号：

MF150HL1-10-M-K-35-114

平均使用寿命：

20000小时

Schneider servo reducer reducer servo motor reducer servo special reducer high precision reducer servo reducer. Schneider servo special reducer high precision servo reducer servo reducer servo motor reducer Schneider servo motor reducer servo motor special reducer Schneider servo motor special high precision reducer ----- low return clearance high output torque integrated double The support transmission mechanism can be used in high-speed and frequent reciprocating operations.
- -
.
The Taiwan company is a manufacturer specializing in the production of reducers. It is also one of the first Taiwanese reducer manufacturers to enter the country. It has good advantages in servo motor selection. There are seven reducers. Large series of products: reducer series servo reducer - series reducer - series servo special reducer - series high precision reducer - series right angle reducer series reducer series advantages:

Small and lightweight
Positive integer ratio Schneider servo reducer full-segment number ratio from~
Low backlash, low noise full series single-segment - within arc minutes
High-precision servo reducer suitable for all brands of servo stepper motors< br/> Sealed design
No need to change oil and easy to install
High torque and low inertia moment of the reducer
Gear surface has been grinded and vibration-free
Easy to install, servo-specific reducer is cost-effective High
Long life and maintenance-free
Servo motor reducer can be made into special reducer according to customer needs, small and lightweight

Taiwan reducer installation steps:

Step 1:
Check whether the specifications of the motor and reducer are correct and whether the interface matches.
Clean the surface of the connection interface between the motor and Schneider servo reducer to remove oil dirt and impurities.

Step 2:
Adjust the position of the input shaft locking screw of the servo-specific high-precision reducer to align with the side hole of the reducer input cover.
If there is a keyway on the motor shaft, remove the fixed key. If there is a balance weight key, insert it into the keyway.
Check the motor shaft diameter. If necessary, add a shaft bushing to the input shaft hole of the servo motor reducer.
Install the motor onto the reducer.
Use a hexagonal wrench to tighten the locking screws at both ends of the input shaft of the Schneider servo reducer according to % of the recommended tightening torque.

Step 3:
Place the motor and servo high-precision reducer vertically.
Use a hexagonal wrench to tighten the reducer flange and motor flange using locking screws and washers in diagonal order according to % of the recommended tightening torque value. (The locking screws should be coated with screw anti-loosening agent in advance).
Use a torque wrench to tighten the Schneider servo reducer reducer flange and motor flange using locking screws and washers in diagonal sequence according to % of the recommended tightening torque value.

Step 4:
Use a torque wrench to tighten the locking screws at both ends of the input shaft of the servo-specific high-precision reducer according to % of the recommended tightening torque value.