Year1
- 表干：
- 10~30
- 比重：
- 0.98~1.0
- 耐温：
- -50℃--250℃
)Typical uses
.Used for oven oven panel, cavity, door panel, microcrystalline plate, structure Parts bonding and sealing silicone, etc.
.The gaps in structural metal parts are sealed to be waterproof and prevent air leakage.
.This bonding sealant has extremely strong adhesion to silicone parts, metal, glass, etc., and is non-corrosive and odorless.
.This silica gel has passed certification and halogen-free certification.
, has good adhesion to a variety of metal and non-metal materials, and is completely non-corrosive to all metal and non-metal materials.
When the product is extruded from the packaging and comes into contact with moisture in the air, it begins to solidify and eventually forms an elastomer.
, heat resistance, cold resistance, adhesion and ease of operation
, superior electrical insulation properties and excellent chemical stability
, impact resistance and physical protection weather resistance (UV resistance, ozone resistance , water resistance)
, non-toxic, and silica gel has excellent physiological inertness.
)
) ) . ). ) ) Factory direct sales, free trial samples for new customers, welcome to call us for consultation.
Cut off the sealing head from the head, install a special injection tool and extrude it before use. It will be cured at room temperature
and the sealing cap must be fastened after use.
When using, the adhesive layer must be fully exposed to the air. The larger the contact area, the faster the curing. Otherwise, it will slow down or even not cure.
The thicker the glue thickness, the longer the curing time, the higher the ambient temperature
(cannot be higher than
℃
), the greater the humidity, the faster the curing speed of the glue layer. , otherwise the curing will slow down.
This product should be kept dry and protected from high temperatures during storage and transportation. The effective shelf life is
Clean the surface: Clean the surface of the adhered or coated object and remove rust, dust, oil, etc.
Apply glue and unscrew (or cut off) the cap of the hose, squeeze the glue onto the cleaned surface to make it evenly distributed, and close and fix the glued surface.
, Curing: Place the glued or sealed parts in the air and allow them to solidify naturally. The curing process is a curing process from the surface to the inside. Within hours (room temperature and % relative humidity) the glue will be cured to a depth of ~. If the glue is applied in a deep position, especially in parts that are not easily exposed to air, the time for complete curing will be If the temperature is low, the curing time will also be extended
After the operation is completed, the unused glue should be capped immediately and sealed. When using it again, if there is a little crust on the seal, just remove it and it will not affect normal use. During the storage process of the glue, a small amount of solidification may occur at the mouth of the tube. After being removed, it can be used normally without affecting product performance.
.) Product packaging
Aluminum tube,
,
Plastic tube
.
)Performance parameters
Model
Appearance black, paste-like
Viscosity
Specific gravity (℃) .~
Surface drying time~
Shaw Hardness~
Elongation at break ( ) ~
Tensile strength ( /) ~
Volume resistivity
Breakdown voltage ( /) ~
Dielectric loss angle Tangent
High and low temperature resistance ℃~℃
Address 1st floor, Industrial Park Building, Sanlian Community, Longhua Street, Shenzhen
(This article is compiled and shared by Shenzhen Xingyong Thermal Silicone Co., Ltd.)
WhatsApp
