Exterior wall scraper machineExterior wall scraper machine picturesExterior wall scraper machine priceExterior wall scraper machine manufacturer

Exterior wall panel hanging machine
)
1. Technical parameters of exterior wall panel hanging machine
, equipment dimensions**
, feeding width
, number of forming rows Row
, cutting system flying saw cutting
, rolling wheel material steel plated with hard chromium
, journal,
2. Technical explanation and maintenance of tile press
The debugging method for the deflection of the pressing plate of the tile press, such as running the plate to the right, pad the left corner (feeding rack), or drop the bottom flat on the right
, find the center of the first and last rows of the equipment, and then tighten it Pull the lock nuts on both sides in a straight line in front and behind the center of the intermediate wheel. After adjusting the gap between the upper and lower shafts, you can adjust the machine along the straight line
. First, line up the front and rear of the machine. Make sure the height of the four corners from the main frame to the upper end of the bottom shaft is consistent. Then, from the first row to the last row, straighten a line to check whether the lower shaft is in a straight line. Adjust the left and right sides of the lower shaft to be horizontal< br/> Maintenance of tile press equipment
It is prohibited for anyone who does not understand the structure, performance and operating procedures of the tile press to start the machine. . It is strictly prohibited to work beyond the minimum closing height, that is, the minimum distance mm from the bottom of the upper sliding box to all working surfaces requires the height after the upper and lower molds are closed
plus the thickness of the upper and lower backing plates plus the thickness of the tiles. It is not allowed to exceed ㎜, when manufacturing the mold, the design should be based on this requirement to avoid machine tool accidents. Always pay attention to the height of the lubricating oil in the sliding box and the body on both sides.
The equipment should be wiped frequently to keep it clean, and no mud or water should be allowed to accumulate