750 floor decking tile press 750 floor decking equipment 750 floor decking machine

Floor decking machine Floor decking
1. Introduction to floor decking equipment
,
Equipment dimensions*.*
, Equipment weight is about tons
, Forming row Number of rows
, working speed/
, control system The whole machine adopts electronic control system control
, motor power. (double motor)
, reducer
, journal
, shaft quality
, wheel quality
, forming area
2.
Precautions for the hydraulic system of the tile press
, for the convenience of operation For maintenance, please keep it away from the wall
. For precise adjustment, the machine frame of the tile press must be calibrated horizontally to maintain precision
. The following matters are important for the installation foundation: the strength must be able to match the weight of the machine. The base must be flat
br/> Installation of color steel equipment (refer to the manual)
Precautions for hydraulic system
① The liquid level of the oil tank should be kept above the center of the oil mark to prevent the oil pump from emptying and refueling through air filtration. filter to remove impurities.
②The working fluid of the oil tank is No. 1 anti-wear hydraulic oil. When the ambient temperature is lower than 10 degrees Celsius, you can use No. 1 anti-wear hydraulic oil. When the ambient temperature is higher than 10 degrees Celsius, you can use No. 1 anti-wear hydraulic oil. Other oils cannot be substituted. Normal operating oil temperature. When the oil temperature is too high, it is necessary to take cooling measures (add cooling water or blow with electric air) or stop the pump. It can only be used after the oil is fully cooled. When the oil temperature is too low, direct operation is not allowed and must be Taking heating measures, the temperature can be increased through external heating.
③Keep the hydraulic oil in the tank clean and do not allow impurities and moisture. During regular use, the oil filter is generally cleaned once a month, the tank is cleaned once every six months, and new oil is replaced at the same time.
④ Before starting the motor, the reversing valve must be in the middle position to prevent the motor from overloading.
⑤ When using the hose, avoid bending and sharp bends, and do not get too close to the hose to prevent injury from explosion. When the pressure resistance of the hose is lower than .times of the rated pressure, leakage and other aging phenomena will occur. The hose should be discontinued and replaced with a new one.
⑥Inspect once a year, clean each piece with light diesel or kerosene, and pay attention to protecting the mating surfaces