Low modulus self-leveling flowing two-component polysulfide sealant for infrastructure waterproofing projects in Zhongshan, Guangdong

产品型号：

双组份

产品规格：

25公斤/桶

厂家：

衡水永盛

//
Low modulus self-leveling flowing two-component polysulfide sealant for Guangdong Zhongshan infrastructure waterproofing project
Minimum order quantity in kilograms
Self-leveling concrete structural joint grouting produced by our company Polysulfide sealant is a specification of two-component polysulfide sealant. It looks like a water-like liquid adhesive. It is like water and can flow in deformation joints. It is relatively thin and is only suitable for deformation joints in cement buildings. Ground joints are fluid. After mixing them in proportion, they can be poured directly into the ground joints and can flow into the deformation joints of the building. When constructing the ground joints on the building plane, use a self-leveling two-component seal. Glue will save time and effort. Its packaging specification is kg/barrel, in which the barrel contains two components. The white polyurethane sealing component is about .kg, and the curing agent is about .kg.

Preparation of sealant
When you open the package, you will find two transparent plastic bags, black and white, in the barrel. The white polyurethane sealant is the group, and the black small package glue is the group curing agent. First, put the group Take it out for use and put it into a plastic bag. You can directly leak the glue into the iron bucket, then pour the group into the iron bucket and stir directly with a stirrer for about half a minute until the glue in the bucket reaches a uniform color without color difference, that is be usable.

Glue injection into expansion joints
The prepared polysulfide glue can be directly injected into the expansion joint with an iron spoon with a sharp mouth, or you can also use a pointed pot to glue into the expansion joint. The glueing speed must be slow, and the density of the grouting in the joint must be ensured. If the glue surface is uneven, you can use a putty knife to gently smooth it. The glue injection tools must be cleaned every time after get off work to prevent the polysulfide glue from solidifying and blocking the glue injection port. The mixed two-component polysulfide sealant must be used within an hour, because the paste colloid begins to solidify slowly under the action of chemical components after an hour, and the best effect can be achieved in a few days.