GZ vibrating feeder

Vibrating feeder (feeder) performance features: simple structure, uniform feeding, good continuous performance, adjustable excitation force to change and control the flow at any time, easy operation, the eccentric block is the excitation source, low noise, low power consumption, Good adjustment performance, no punching phenomenon. If the closed body is used, it can prevent dust pollution. The vibration is stable, reliable, and has a long life. The excitation force can be adjusted, and the flow rate can be changed and controlled at any time. The adjustment is convenient and stable. The vibration motor is used as the excitation source and the noise is eliminated. Low, low power consumption, good adjustment performance, and no rush phenomenon. It has a simple structure, reliable operation, easy adjustment and installation, light weight, small size, and easy maintenance. When a closed structure body is used, dust pollution can be prevented.
The vibrating feeder has a simple structure, is easy to operate, does not require lubrication, consumes little power and can evenly adjust the ore feed amount, so it has been widely used. Generally used for loose materials. According to the equipment performance requirements, the pressure of the material on the tank body should be minimized during configuration design. According to the manufacturer's requirements, the effective discharge port of the warehouse material should not be larger than one-quarter of the tank width, and the flow speed of the material should be controlled within/the feeding amount is relatively large. For large materials, the ore blocking plate at the bottom of the silo should be installed with a sufficient height so as not to affect the performance of the feeder. The ore blocking plate must not be fixed on the tank body. In order to enable the silo to be discharged smoothly, the inclination angle of the rear wall of the silo is best designed to be degrees.
Purpose of Vibrating Feeder The vibrating feeder can feed lumpy and granular materials from the silo to the receiving device evenly and continuously. In the sand and gravel production line, the crusher can be fed continuously and evenly to avoid clogging of the crusher's material opening.
Working Principle of Vibrating Feeder This machine uses the rotation of the eccentric block in the vibrator to generate centrifugal force, which causes the movable parts such as the screen box and the vibrator to make forced continuous circular or approximately circular movements. The material follows the screen box
Installation requirements for motor vibrating feeder
When the feeder is used for batching and quantitative feeding, in order to ensure uniform and stable feeding and prevent the material from flowing, it should be installed horizontally. Materials are fed continuously and can be installed with a downward tilt. For viscous materials and materials with large moisture content, it can be installed with a downward tilt.
The swimming gap left by the feeder after installation should be horizontal and the suspension device should be flexibly connected.
Before testing, all bolts should be tightened once, especially the anchor bolts of the vibration motor. They should be retightened once every hour of continuous operation.
When driving, the two vibration motors must rotate in opposite directions to ensure the stability of current and noise. If any abnormality is found, the machine should be stopped in time.
The machine bearings should be filled with grease once a month, and lubricating oil should be added once a month during high temperature seasons.
Maintenance and requirements for type motor vibrating feeder
During the operation of the feeder, the amplitude, vibration motor current and motor surface temperature should be checked frequently. Stable, if abnormal conditions are found, the machine should be shut down immediately for processing.
The lubrication of the motor bearings is the key to the normal operation of the entire feeder. During use, the bearings should be regularly filled with second-fluid molybdenum grease, once every two months, and every month during high temperature seasons. Once every six months, dismantle and repair the motor and replace the internal bearings.
Mobile phone
Contact person
Ms. Wu
Contact number