Discover the cause of the sand washing machine failure and eliminate it promptly without any worries

During the use of the sand washing machine, some failures will inevitably occur, but don't worry. Now let me tell you the causes and troubleshooting methods of the sand washing machine failure, so that you don't have to worry.
Is a gear easily damaged?
The reason is that the shaft of the sand washing machine and the low-speed shaft of the reducer did not reach the specified parallelism.
Set the time for the elimination method, refuel at the specified time, and adjust the shaft of the sand washing machine and the low-speed shaft of the reducer to meet the requirements.
Is the sand washing capacity of the second sand washing machine reduced or is the sand leaking?
The reason is that the sand mesh is damaged and the bolts that are not firmly fixed on the sand mesh fall off.
Troubleshooting method: Check and repair or replace the sand screen regularly and tighten the bolts.
Is the three-frame vibration severe?
Cause The bolts of the coupling frame are loose. The bolts of the bearing seat are loose.
The troubleshooting method for both is to check and tighten the bolts regularly.
Is the fourth transmission part too noisy?
The reason is insufficient lubrication of the gears and changes in gear spacing.
Troubleshooting method: Add enough grease regularly, check, adjust and tighten the reducer anchor bolts.
Five bearing wearing parts?
The reason is that the parts are out of oil or the sealing ring is damaged, and there is a lack of maintenance and cleaning after long-term use.
Troubleshooting method: Check regularly and refuel as required or replace the sealing ring and clean it regularly.