Problems encountered in the use of linear vibrating screens and their solutions

There are many application areas for linear vibrating screens, and problems will inevitably be encountered during use. Common phenomena include slow discharge of screened materials or blockage of the screen. But don’t worry, let me analyze and solve these two problems for you below. hope that it can help us!
The linear vibrating screen discharges impurities slowly during use
You can check whether the base of the linear vibrating screen is working in a horizontal state. Because the screen machine is in a horizontal state, it will directly affect the screening efficiency. Therefore, if it is not in a horizontal state, please adjust it in time. The vibrating screens produced by Shanghai Oriental Hongtu Mining Machinery Vibrating Screening Machine are equipped with shock-absorbing anchor bolts. Users can adjust according to actual conditions.
Check whether the screen mesh and the debris discharge port are level. If there is no problem with the level, it means that the manufacturer has a problem with the design of the vibrating screen, and this situation should be reported to the manufacturer. Vibrating screen manufacturers that are responsible for users have self-inspection for each vibrating screen before leaving the factory!
The angle of the upper and lower eccentric blocks of the vibration motor is adjusted. The smaller the adjustment angle, the material will spread out faster. The larger the adjustment angle, the slower the material will spread outward. So you should pay attention when adjusting the angle.
When using the linear vibrating screen, avoid blocking the mesh
When using it, avoid materials with high moisture content and fibrous materials. Check whether the wire mesh of the woven screen is too thick and the screen mesh is too thick. If the design is unreasonable and the top is small and the bottom is large, the material particles will get stuck, causing network blocking.