Year1
Supply air shower room manufacturer Where is the air shower room manufacturer Hong system supply
>>
In the original air shower Based on the shower room configuration, it is equipped with an advanced built-in automatic door opener system, which eliminates the traditional door closer, making this series of air showers truly fully automatic. With the cooperation of the inner and outer non-contact hand sensor switches or microwave sensor probes, the two doors in and out of the air shower room can be automatically opened by induction, with a slight delay (retention time > to seconds) adjustable, and then automatically closed again. When the door opens to the fast position or before the speed position, the system automatically performs buffer braking, which is very fast and smooth. The entire process of opening and closing the door does not require pushing or pulling by hand, it can be opened and closed automatically.
At the same time, the system>C controller controls the opening and closing of the sensor probe or hand sensor switch signal under the feedback of the door magnetic door closing signal. Through the cooperation of the door opener or electric control lock, two-way access is realized. The interlocking control for exiting can achieve both automatic opening and closing and interlocking.
Features
Since this series of air showers is truly fully automatic, the entire process of entering and exiting the air shower does not require manual push and pull contact. Compared with translational induction automatic doors, it has lower cost, less space, and higher failure rate. few.
Technical Parameters
>.
The air shower indoor and outdoor boxes are made of multi-layer pickling-resistant electrostatically sprayed cold-rolled steel plates or stainless steel materials
>.
The left and right sides A total of three sides blowing, side and top, for better effect
>.
Fan: large air volume, low noise and high air pressure centrifugal fan
>.
Control method: manual and automatic integration Control panel, automatic induction shower, when people enter the air shower room, automatic shower, manual or automatic can be switched freely
>.
High efficiency filter efficiency>.@., junior and medium efficiency filter pre-filtration system
>.
Door closer: international brand door closer, automatically closes the door when people enter the air shower room, durable
>.
Nozzle distribution: stainless steel all-round adjustable nozzles, Blowing on the left, right or top three sides has better effect. The air outlet speed is >/above
>.
Time: Blowing time > adjustable, using soft contact control switch, digital display control Panel
>.
Lighting: Equipped with clean lighting, which is more suitable for clean room lighting principles than ordinary lighting
>.
Double doors use high-quality stainless steel handles and sealing devices To ensure tightness, a visible float glass observation window is set up on the door
>.
Excellent details: The internal welding joint is reinforced with keel, which is stronger, the internal sealing material is sealed with foamed polyurethane, and the exterior is made of large Brand sealant seal
>.
Air shower power supply: >, three-phase four-wire system (power supply can be customized according to customer requirements).
Infrared automatic induction blowing air shower room process
>.
The entrance door of the air shower adopts an infrared induction device. The induction range is >.meter. When a person approaches .meter, the infrared induction will automatically open the door. , when people enter the air shower room, other employees to be showered should stay outside the . meter area to avoid infrared detection of the presence of someone and the inability to close the door. It is recommended to draw a line r outside the air shower area to be showered
>.
When someone passes in front of the air shower door but does not actually enter the air shower room, when the person leaves, the door It also closes automatically, but because the air shower detects that there are no people in the air shower, it will not blow the shower
>.
When a person enters the air shower, the door will automatically close within > seconds. When the door is closed, the fan automatically starts the air shower. At this time, all the induction signals for entering and exiting the door are turned off, and the door will no longer be closed. The air shower time is factory set to seconds and can be set on the control panel r at the entrance. (Note that when people enter the air shower area and the door automatically closes without showering, please note that there is an infrared sensor probe in the air shower area. Personnel must stand in the area detected by the infrared probe before the air shower will start. )
>.
When the air shower time is up, the fan will automatically stop, the light will go out, and you will receive a shower completion signal when you go out, and it will open automatically when you go out. It takes time for the door machine to buffer the signal. , please do not forcefully push or pull the handle with your hands
>.
When the door is opened and people leave, the door will automatically close, and the next group of people will be air showered, and the cycle will be repeated
>.
This motor equipment has two manual remote controls. If the automatic one is not used, the manual remote control can be used to control it. The closing buffer time is factory set to > seconds and can be set freely. Please check the manual for details
>.
Note: This door motor adopts the form of automatic induction. The door handle is used to open and close the door under special circumstances of power outage. Please do not force the door to push or pull, otherwise it will easily cause the motor to burn and personal damage. Case.
WhatsApp
