For roof waterproofing, choose Aidis K11 flexible waterproof coating. It is super flexible and is not afraid of leaks.

Flexible waterproof coating
Product introduction
Flexible waterproof coating is a two-component, acrylic polymer-modified cement-based waterproof coating. The liquid material is made of acrylic polymer imported from the United States and other additives are added to the powder. After mixing domestic famous brand cement and additives, a chemical reaction occurs to form a tough elastic waterproof membrane, which is effective against concrete and mortar. Good adhesion can form a tight and permanent bond with it, preventing water penetration.
Execute the national standard/"Polymer Cement Waterproof Coating" standard
Features and Advantages
It is flexible and can adapt to a certain degree of vibration and displacement of the building structure.
It has strong knot strength and can seal loose base surfaces, special-shaped parts and precast joints.
Construct on wet substrate.
Cement plastering, pasting stone, ceramic tiles, etc. directly on the waterproof membrane.
It has super waterproof function.
Guaranteed product, can be used in drinking fountains.
Scope of application
Waterproofing of internal and external structures, prefabricated structures, brick walls, etc.
Waterproofing parking lots, tunnels, drainage and water supply pipes, floor rooftop walls and floors, swimming pools, drinking water pools, etc.
For building structures that may experience slight vibrations, shifts, and cracks, the areas around pipe mouths, post-cast belt interfaces, joints, or expansion joints should be waterproofed.
Base surface treatment
The surface must be stable, clean, smooth, free of dust, oil, peeling, hollowing, and looseness.
Obvious pores and blisters must be plugged and smoothed with cement mortar first, and sharp edges should be removed.
Before construction, the base surface must be fully moistened with water (but no water should accumulate).
Instructions for use
Pour the powder into the additives and stir thoroughly for several minutes until there is no powdery slurry. Use it within about an hour.
Moisten the surface with clean water, and evenly apply the stirred slurry crosswise, taking care to avoid missed brushing. Generally, it is required to apply at least one layer (thickness or more).
After finishing one layer, you must wait for it to dry slightly before applying the second layer.
Reference dosage
Depends on the flatness of the base surface
Degree
, approximately
㎡.
Degree
, about
㎡.
Precautions
It is required to construct in an environment of ~ ℃ within 1 hour after construction. Pay attention to prevent rain, strong sunlight or freezing. Please wash tools and equipment with water immediately after use.
Storage
Keep in a cool and dry place. The shelf life of unopened products is one month.
Packaging
kg/set, kg/barrel, kg/barrel, kg/barrel