PY-175 disc grinder testing machine wholesale price

Wholesale price of disc grinder testing machine
Product features: Professional disc grinder manufacturer and seller, quality assurance with the best price, lifelong maintenance, stable operation and low noise,
Disc grinder Detailed information:
Main structure and working principle of disc grinder
. Structure: mainly composed of bracket (), bearing seat (), grinding seat (), movable grinding disc (), fixed grinding disc (), It consists of a movable grinding cover (), a pulley () and a motor.
.Working principle: The motor drives the pulley () to rotate, and the pulley () drives the movable grinding disc () on the main shaft () to rotate, causing the movable grinding disc and the fixed grinding disc () to produce relative rotational motion, so that the material in the middle of the two discs Crush and fall into the drop box () from the gap between the two plates. The discharging granularity can be adjusted by adjusting the handwheel ( ) to adjust the gap between the two discs to control the granularity.
Lifting and installation of disc grinder
. Lifting: This machine does not have a lifting device and can be transported manually.
.A cement concrete foundation is required to install this machine. The layout of the anchor bolts is shown in Figure 1. The anchor bolts are approximately exposed to the anchor plane.
. The power supply and safety grounding power cord are connected by the user. The wire is inserted through the rear hole of the machine, and the grounding is reliable.
Commissioning, use and maintenance of disc grinder
. Before commissioning, open the front cover () and check whether the rotating belt rotates flexibly. If it does not rotate flexibly, loosen the adjustment handwheel and then rotate the belt until it flexibly rotates. Check whether each fastener is tight and lock the wing nut () before test run. Do not put materials during test run.
. Open the plug on the movable grinding cover, loosen the wing nut, and adjust the handwheel (). From the plug hole, the gap between the two grinding discs should not be too large, but too tight will also cause difficulty in starting. Lock the butterfly nut, tighten the plug, add the material from the inlet of the movable grinding cover, and turn on the power supply. If it is found that the discharge granularity does not meet the requirements, the handwheel should be adjusted until the requirements are met. Both wing nuts must be locked during operation, otherwise the use will be affected. After the work is completed, cut off the power supply and take out the materials from the blanking box. To replace the sample, in order to ensure accurate test data, loosen the wing nut II, open the movable grinding cover (), and use a brush to clean the residue in the working room.
.For maintenance, open the upper cover of the whole machine, unscrew the two guide screws (), (), inject lubricating oil into it, and then screw in the two guide screws (note, do not pre-tighten the two bearing sleeves ( ), (), otherwise the lubrication of the bearing sleeve will be inflexible and the adjustment handwheel cannot adjust the gap between the two grinding discs). Close the upper cover. When the movable grinding disc () needs to be replaced, use a wrench to loosen the three screws fixing the movable grinding disc.
Introduction to disc grinder:
It is mainly used for crushing medium ore and cement clinker. It is one of the main equipment in laboratories or laboratories in metallurgy, geology, building materials, chemical industry and other industries. The equipment is easy to operate, has good dustproof performance and beautiful appearance.
Main technical parameters of disc grinder
Grinding disc diameter
Maximum feed particle size
Discharge particle size.
Productivity㎏
Spindle speed r
Motor model
Power.
Dimensions
Weight
Disc grinder maintenance method:
Open the upper cover of the machine and unscrew the two guide screws (), (), just inject lubricating oil into it, and then screw in the two guide screws (note, do not pretighten the two bearing sleeves (), (), otherwise the lubrication of the bearing sleeve will be inflexible, and the adjustment handwheel cannot adjust the gap between the two grinding discs). Close the upper cover. When the movable grinding disc () needs to be replaced, use a wrench to loosen the three screws fixing the movable grinding disc.