HAD heatless regeneration adsorption dryer

Design Features
◆
Pressure Swing Adsorption◆
Short-cycle adsorption cycle isothermal operation to preserve adsorption heat and natural desorption effect is good◆
The cycle period can be programmed at the factory on site◆
The contact time between the small air flow and the adsorbent after thermal/hydraulic calculations is greater than seconds◆
The adsorbent filling amount is extremely sufficient to ensure the lowest dew point of the outlet air◆
Fully electronic programmable controller man-machine Friendly interface, automatic and continuous display of twin tower operating conditions ◆
Accurate action, stable and easy to operate ◆
The inner wall of the barrel is treated with cold galvanizing for anti-rust treatment and will not rust for years The valve or valve structure works reliably and has a valve life of up to 10,000 operations ◆
The preferred valve form ensures the feasibility and convenience of on-site repair and replacement ◆
The high-precision regeneration gas two-way regulating valve ensures continuous and stable regeneration pressure of the regeneration gas flow Low to critical ◆
The moisture content of the regeneration gas outlet is controlled in a sub-saturated state, and there is no concern about condensation in the muffler and exhaust channel. ◆
Interfaces for low-load regeneration energy-saving control and dew point online detection are reserved.