Corner reducer

产地：

台湾

型号：

WTH060L1-5-14-50

平均使用寿命：

20000小时

Angle reducer, angle planetary reducer, hollow shaft reducer, Taiwan angle reducer, angle reducer, bevel gear reducer, hollow shaft output reducer. Taiwan's D angle reducer is suitable for occasions that save installation space. The low backlash replaces the worm gear reducer. Compared with the worm gear reducer, the positioning accuracy and transmission efficiency are greatly improved. ---This model is a hollow shaft output reducer with single-side shaft output and double-side shaft output specifications.
- - -
.
Things to note when selecting an angle planetary reducer:

The selection of an angle planetary reducer should follow the principle of combining applicability and economy. That is to say, the various technical indicators of the angle reducer can not only meet the requirements of the equipment but also save costs. Excess or failure will result in cost waste, so the correct selection of the angle planetary reducer is very important.

When selecting a corner hollow shaft reducer, its structural type, load-bearing capacity, reduction ratio, output speed, axial force, radial force, torsional rigidity, backlash and other internal indicators should also be fully considered during installation. Form, working conditions, working environment and other external structures. The following are the most basic requirements for selecting a hollow shaft reducer:

Installation dimensions: that is, the size of the front end of the servo motor. When selecting the angle planetary reducer, the input end of the angle hollow shaft reducer must exactly match the size of the output end of the servo motor.

Reduction ratio: Motor rated output revolutions per minute/reduction ratio = how many revolutions the reducer outputs per minute. The angle reducer should try to use a reduction ratio as close to the ideal as possible to ensure the ideal speed.

Torque: rated output torque of servo motor (stepper motor is holding torque) * reduction ratio. The rated output revolutions of the corner hollow shaft reducer must be greater than this value. If it is less than the corner reducer, the service life will be shortened. In severe cases, the shaft may break or the teeth may collapse.

Return backlash: Return backlash (accuracy) r (one circle of the output shaft of the angle planetary reducer, one degree = arc minute) is what we often call the arc minute unit:. The smaller the return clearance, the higher the accuracy and the higher the cost. Users can just choose a reducer that meets their accuracy requirements. Also consider lateral/radial forces and average life. Reducers with large lateral/radial forces are relatively reliable and less prone to problems during installation and use. Usually its average life span far exceeds the life span of the servo motor it is equipped with.

Installation method of corner hollow shaft reducer:

Apply a little anti-rust oil to the motor output shaft and flange.
If there is a bushing, when placing it into the input shaft of the angular hollow shaft planetary reducer, pay attention that the groove on the bushing must be aligned with the groove on the input shaft of the reducer.
Place the motor to be installed on the platform with the motor output axis upward, then secure the motor and remove the key.
Carefully align the groove on the input shaft of the servo reducer with the key groove on the motor and slowly slide it in.
Lock the fixing screw on the input shaft of the angle reducer with the first torque.
Tighten the fixing screws of the motor and reducer.
Increase the torque evenly and gradually (three times) to tighten the fixing screws on both sides of the input shaft of the bevel gear reducer.
Please do not hit the output shaft of the reducer with gravity to avoid damaging the internal mechanism of the reducer.

Notes on angle reducer:
Installation site: Confirmation of oil: When ordering, the softened oil of this type of product is semi-solid and does not require oil change, but it must be noted that it should be used below ℃ Let us know in advance so we can add antifreeze. We must also be informed to install additional protective measures in acid and alkali places.
Servo motor: When ordering, the factory should be informed of the required connecting flange and shaft dimensions of the servo motor.
Installation of the angle planetary reducer: The reducer body is a very precise product, so care must be taken during installation to strictly prohibit impacting or hitting the axis or any part with a hammer.