Taiwan VGM Jusheng two-stage gear reducer

产地：

台湾

型号：

MF40HL2-20-M-K-8-30

平均使用寿命：

20000小时

Micro precision reducer Jusheng reducer Taiwan precision reducer Micro reducer two-stage gear reducer Jusheng precision reducer Taiwan micro reducer Micro gear reducer Taiwan reducer Micro two-stage reducer Taiwan two-stage gear reducer Jusheng reduction Taiwan Jusheng micro two-stage precision gear reducer - small size, low backlash, high transmission efficiency, gear materials are all imported steel, high strength, average service life is above.
-dd
Installation method of Taiwan Jusheng micro precision reducer:
Apply a little anti-rust oil of Jusheng reducer on the motor output shaft and flange
Taiwan micro reducer such as When placing the shaft sleeve into the input shaft of the Jusheng reducer, pay attention that the groove on the shaft sleeve of the double-stage gear reducer must be aligned with the groove on the input shaft of the reduction gear.
Place the motor to be installed on the micro reducer on the platform with the motor output axis facing upwards, then secure the motor and remove the key.
Align the groove on the input shaft of the micro gear reducer with the key groove on the motor and slowly slide it in.
Lock the fixing screw on the input shaft of the Jusheng two-stage gear reducer with the first torque.
Taiwan precision reducer locks the fixing screws of the motor and reducer.
Increase the torque of the micro reducer evenly and gradually (three times) and tighten the fixing screws on both sides of the input shaft of the reducer.
Please do not hit the output shaft of the reducer with gravity to avoid damaging the internal mechanism of the reducer.
Precautions for selecting Jusheng micro reducer:

The selection of Taiwan Jusheng precision micro reducer should follow the principle of combining applicability and economy, that is, the various technologies of the reducer Index Jusheng two-stage gear reducer can not only meet the requirements of the equipment but also save costs. Excess or failure will result in cost waste, so the correct selection of micro gear reducer is very important.

When choosing a Taiwan precision gear reducer, you should consider its structural type, load-bearing capacity, reduction ratio, output speed, axial force, radial force, torsional rigidity, backlash and other intrinsic indicators. Taiwan micro reducer also Full consideration should be given to the installation form, working conditions, working environment and other external structures. The following are the most basic requirements for selecting a reducer:

Installation dimensions: that is, the size of the front end of the servo motor. When selecting a micro gear reducer, the input end of the reducer must exactly match the size of the output end of the servo motor.

Taiwan micro precision reducer reduction ratio: motor rated output revolutions per minute/reduction ratio = how many revolutions the reducer outputs per minute Taiwan gear reducers should try to use a reduction ratio as close to the ideal as possible to ensure the ideal of rotational speed.

Torque: Servo motor rated output torque (stepper motor is holding torque) * reduction ratio. The rated output revolutions of Taiwan's two-stage gear reducer must be greater than this value. If it is less than the reducer, the service life will be shortened. In serious cases, the Jusheng reducer may break the shaft or collapse the teeth.

Return backlash: Return clearance (accuracy) r (one circle of the output shaft of the micro precision reducer is one degree = arc minute), which is what we often call the arc minute unit:. The smaller the return clearance, the higher the accuracy and the higher the cost. Users can choose a two-stage gear reducer that meets their accuracy requirements. Also consider lateral/radial forces and average life. Miniature precision reducers with large lateral/radial forces are relatively reliable and less prone to problems during installation and use. Usually the average life of the micro reducer far exceeds the life of the servo motor it is equipped with.