Dongying epoxy zinc-rich paint manufacturer

Product performance of Dongying epoxy zinc-rich paint manufacturer
Component A consists of epoxy resin, ultra-fine zinc powder, additives, solvents, etc., and component B is a polyamide curing agent.
It has cathodic protection and excellent anti-rust properties.
The paint film has excellent adhesion to the steel surface.
The paint film has excellent oil and water resistance.
Scope of application
Suitable for long-term rust prevention of ships, gas tanks, oil tanks, bridges, iron towers, offshore drilling platforms and other steel structures.
Physical parameters
Color gray
Glossy and matte
Theoretical coating rate/㎡ (based on dry film, excluding loss)
Specific gravity is about
Flash Component A component ℃
Drying time ℃ Surface dry & fully cured
Construction instructions
Mixing ratio Part A (paint) Part B (solid)
Curing time ℃
Construction life ℃
Construction method
Construction method Nozzle hole spray pressure Maximum dilution amount
Airless spraying.~. ~ %
Air spraying.~. .~. %
Rolling, brushing &&%
Thinner Epoxy thinner
Overcoating time
Substrate temperature ℃ ℃ ℃
br/>
Tool Cleaning Epoxy Thinner
Paint Film Thickness Wet Film Dry Film.
Surface treatment Steel surface treatment is performed as per. Shot blasting or sandblasting up to grade . Or manual and power tool rust removal up to grade . The surface after rust removal should be free of oil and dust before painting. And paint it immediately to avoid secondary rust.
Construction conditions
The coating must be thoroughly stirred evenly before construction.
The surface temperature of the substrate is higher than the dew point and below ℃, and the relative humidity is below %. When the substrate temperature is below ℃, it is not suitable for construction.
The supporting coatings include chlorinated rubber topcoat, acrylic polyurethane topcoat, epoxy mica anticorrosive primer, high chlorinated polyethylene coating, epoxy asphalt anticorrosive coating, and anticorrosive coating topcoat.
Packaging specifications: Part A is packed in 1 liter container, and Part B is packed in 1 liter container.
This product should be stored in a cool, dry and ventilated indoor warehouse. The storage period at room temperature is one year.
Pay attention to ventilation at the construction site, strictly prohibit fireworks, and keep away from open flames, heat sources, and oxidants. Paint construction workers should wear protective equipment during construction to avoid long-term inhalation of solvent vapor or paint mist to prevent damage to the skin and eyes. Wash skin with soapy water immediately, and rinse eyes thoroughly with water immediately. If you swallow it by mistake, induce vomiting with warm water and then seek medical examination.
The service life and anti-corrosion effect of the knee membrane depend on factors such as surface treatment during painting construction and paint film thickness. Users should meet the requirements of surface treatment and construction conditions when using it.
The number of coats of this coating should be determined according to the use environment and design requirements, and the final thickness of the coating film should be determined by the design specifications.
The relevant data in this manual are theoretical values or accumulated through experiments. Actual product may vary slightly.
Qingdao Baiwei Paint Co., Ltd.
Qingdao Runmeijia Anticorrosive Coating Co., Ltd.
Sales Manager Liu Changjiang
Mobile phone
Landline
Email@
Address: Ankang Road, Huangshan Economic Zone, Wangtai, Huangdao District, Qingdao