Year1
- 型号：
- THO4065
- 规格：
- 公斤装
- 包装：
- 铁罐装
Product
Name
Name
>Thomas modified epoxy resin thermal cycle high temperature resistant adhesive (
)
Overview
>This product is an epoxy resin modified adhesive. The adhesive is curable at room temperature. Its fluidity, color, temperature resistance, etc. can be adjusted appropriately. After curing, it is resistant to high temperatures and Excellent high and low temperature cycle performance.
Applicable
Scope
Scope
>This product is widely used in self-adhesive and mutual adhesion of steel, concrete, composite marble, composite stone, alloy, sensors, etc. Composite, surface coating
.
and good heat exchange performance.
Performance
Performance
Features
Points
>
Appearance:
The components are milky viscous liquid with no solid particles.
B
Component is a white mixed viscous thixotropic liquid.
>
The curing speed is fast,
℃
, it will cure at the beginning of
hours, close to the hour Maximum bond strength.
>
High bonding strength, good toughness, good durability, and excellent UV resistance.
>
It has good temperature resistance and can adapt to a wide temperature range. After bonding, it still has a good bonding effect at a higher temperature.
>
The glue has moderate viscosity, no bubbles, good leveling performance, and good surface finish after curing.
>
The bonding surface does not need strict treatment. The two components are prepared in proportion and are easy to use.
>
Excellent media resistance, resistant to oil, water, acid, kerosene, ethanol, alkali, radiation, etc.
>
Safety and toxicity characteristics: It has a very slight odor, no inhalation hazard, and is actually non-toxic after curing.
>
Storage stability is good, and the storage period is several months.
>The main technical performance indicators are as follows: Cycle temperature resistance range
:
+
℃
Cycle alternation time/time
>Normal temperature curing Post-shear strength parameters:
℃
*
>
℃
*
day
>
℃
*
>
>
>
>
Use
Use
Method
Method
>
Remove rust, decontamination and wipe the adherend.
>
、Place the
,
B
components according to the mass ratio
:
.
Mix the proportion thoroughly before use.
>
,
Apply the prepared glue to the surface of the adherend, close it, compact it, and let it sit for
~
hours.
>
, Use period (
/>℃
)
>
, If necessary, after coating For glass fiber molding, you need to wait for the glue to be in the initial curing time after the glue is coated on the material, and then hot press or cold press the molding.
Note
Note
Things
>
,
Glue removal tools must not be mixed.
>. If crystallization of the components is found, it can be dissolved by putting it in ℃ hot water and heating it
>.
>,
If the glue touches the skin, rinse it with soapy water immediately
.
>,
The unused glue should be covered and placed in a cool and ventilated place. at.
WhatsApp
