Rectangular rounded metal corrugated compensator

Rectangular rounded metal corrugated compensator mobile phone

This product is one of the supporting equipment for the flue duct of the power station. The corrugated rounded rectangular compensator adopts a rectangular cross-section and a rounded corrugated shape. A single expansion joint in the pipeline is subjected to two-dimensional displacement. The elbow pipe composed of expansion joints can withstand three-dimensional displacement. Rectangular rounded metal corrugated compensator products are available in full-height and office-height types. Users can choose multiple wave sections according to the flue size and stress and strain requirements.
Selection instructions
After the user selects a suitable rectangular compensator based on the thermal displacement of the piping system, at least the circulating medium in the pipe, the design pressure of the flue duct, and the maximum temperature during operation must be provided. The outer dimensions (length, width) of the cross-section of the flue duct are selected in terms of wave shape (full height, half height) and wave number (the number of waves in a single corrugation does not exceed the wave number) so that we can carry out the structural design and manufacture of the compensator.
It is recommended that the maximum allowable expansion amount per wave is the full-height type △ and the high-height type △
The dust-proof board does not need to be used for the air duct or the pipe with less dust. The dust-proof board should be used for the dusty flue.
. In order to reduce the number of nodes of the corrugated pipe, cold drawing should be considered.
. The standard half-height type compensator is suitable for occasions where the cross-sectional area is less than square meters and the outer dimensions of the flue duct are smaller than or larger than one side. Standard full-height type Corrugated compensators are suitable for all flue ducts.