Supply Zhongpeng nano leak plugging king

规格：

5kg/桶

Nano Leakage Plugging King
Leakage Plugging King refers to a high-performance, latest high-tech product that integrates inorganic, alkali-free, waterproof, moisture-proof, anti-cracking, anti-seepage and leakage-stopping functions. Its most amazing feature is that it solidifies quickly and its density and strength are much higher than the current high-grade concrete
!
It can start to solidify one minute after mixing, final solidify in three to four minutes, and can withstand pressure for one day. The intensity can reach
or above. Construction can also be carried out directly on wet substrates. It is used for emergency rescue, road restoration, etc. It can be restored to its original state in one hour and can be opened to traffic in four hours. It is used for waterproofing projects. It can bring water and pressure to stop leakage immediately. This product is simple to operate and can be used after just adding water to mix it. It is non-toxic, harmless and pollution-free. Portland cement can be added to adjust the retarding time. Same lifespan as the building.
Product Features
This product has the function of quickly plugging water with water. The initial setting time is only two minutes and the final setting time is fifteen minutes.
This product can be applied on both the front and back surfaces, and is combined with the base layer to form a non-aging whole, with extremely strong water resistance.
. The solidification time of this product can be adjusted arbitrarily according to user needs. Waterproofing and bonding are completed in one go, and the bonding force is strong.
This product has no corrosion to steel bars.
Scope of application
Non-retractable concrete or mortar structures such as kitchens and bathrooms, basements, and roofs. It can enhance the waterproofing of the arcs at internal corners and around pipes, as well as various wall pipes and sleeves. It has excellent results in repairing defects around pipes and internal corners. It can also be used to bury hooks, seal equipment railings, etc.
, plugging leaks in family bathrooms, kitchens, pipes, and walls
, plugging leaks in residential floors, basements, and floors
, emergency repairs and plugging of building construction projects, rapid road repairs Repair
, emergency repair and plugging of civil air defense and tunnel projects
, emergency repair and drainage project of pipe joints of water companies
, rapid repair of prefabricated components in prefabricated pipe component factories.
Notes
The gouache-to-powder ratio can be adjusted appropriately depending on the substrate, weather, and construction conditions.
The normal condensation time is
minutes, but it may fluctuate due to different water consumption and construction temperature.
It will generate a lot of heat when condensing, so care should be taken to avoid burns.
This product is highly alkaline, so appropriate protective measures should be taken during construction.
When the ambient temperature is lower than
degrees, warm water around
degrees should be used for stirring.
Technical indicators
Instructions for use
First, chisel the leaking point into a bell mouth, clean up the debris or loose powdery matter, expose the hard and rough surface, and moisten it with water
Take an appropriate amount of this product and put it into a mixing container, add water according to the proportion (mass ratio) of aqua regia for plugging water
, and stir quickly and fully evenly. When the ambient temperature is low, the temperature of the accompanying water needs to be increased appropriately< br/> Knead the mixed leak-proofing clay into a wet dough ball with your hands. When you feel that the clay begins to heat up, quickly press the clay into the cut hole in the direction of the leakage, and then immediately flatten it with a wooden board and press it firmly, It can be hardened (about
minutes)
. For water seepage pits, you can directly put the dry powder of Leak Stopping King into the pit, and then press it until it hardens
. For serious water leakage cracks , use the drainage method, first plug the cracks, and finally plug the drainage holes
For large-area leaks, find the seepage points, block them, and then use cement waterproof mortar to plaster the surface.
Storage
Store in a cool and dry place. After opening the bag, it is generally used once. If it cannot be used up, the remaining part should be sealed quickly. During transportation, it should be protected from rain and
exposure to the sun.