Factory direct sales of Swinger ECM epoxy repair mortar, preferential treatment for large quantities

抗折强度（Mpa）28d：

6.49

抗压强度（Mpa）：

≥35

粘结强度（Mpa）：

2.8

Epoxy repair mortar
Scope of application
:
Fire-resistant and high-temperature resistant, it is suitable for treating defects such as honeycombs, loopholes and exposed reinforcements on the surface of concrete structures.
Repair damage to concrete structures, stair treads, etc.
The bottom layer should be leveled when bonding steel reinforcement and bonding carbon fiber reinforcement.
It can be used as corrosion-resistant materials in corrosive environments such as seawater, saline-alkali areas and chemical plants.
Product Features
:
It has the properties of impermeability, frost resistance, salt resistance, alkali resistance, weak acid corrosion resistance, and has strong adhesion with a variety of materials.
The thermal expansion coefficient is close to that of concrete, so it is not easy to detach from these bonded base materials and has good durability.
Can be applied on wet substrate surfaces without drying, and can be hardened in humid environments or underwater.
It does not burn, explode, does not pollute the environment, and is harmless to human health.
Low cost, only epoxy resin mortar 3-.
Easy to operate and construct, similar to ordinary cement mortar construction, easy to clean, and can be cleaned with water.
Physical performance indicators
:
Test items
Test results
Flexural strength

Compressive strength




Neutralization resistance

Bonding strength
Normal temperature

Repeated hot and cold
< br/> Water permeability

Water absorption (/3)

Water absorption coefficient (/)


Instructions for use
:
Check that the packaging of this product is intact and the labels are correct.
Open the lid of the bucket and take out the 3 bags of pre-ingredients marked with "B" in the bucket.
After shaking ingredients B and B, pour them into the bucket respectively, and stir thoroughly, then slowly pour the labeled powder into the bucket while stirring
and stir until evenly. The mortar shape is enough. If the mixture becomes viscous or difficult to stir evenly, you can add clean water to this package and stir without affecting the final performance of the product.
Notes
:
This product is a cement-based material, and it takes days to fully harden. You can proceed to the next process within hours of using this product. The mixed epoxy mortar should be used up within an hour. If it becomes dry and thick within this time, you can add appropriate water and stir evenly before use.
Packaging and storage
:
The packaging specification of this product is/barrel.
The unopened shelf life is one month. If the shelf life is exceeded, it can only be used after passing the inspection.
This product is non-toxic, odorless, non-flammable and non-explosive. It meets the requirements of green environmental protection and can be stored and transported as general cargo.
/barrel
, yuan/barrel