American Nalco OSM1135 reverse osmosis scale inhibitor/dispersant

规格：

25公斤/桶

包装：

塑桶

U.S. (Nalco) high-efficiency membrane scale inhibitors. We will provide you with professional water quality laboratory analysis agent selection and on-site technical services in Greater China!
◇Production
Suitable for salt solutions with a value of . and a silica content less than / at a temperature of ℃
.
Current value: (pure state)
●Viscosity: (
℃)
◇Regulatory status
This product has been approved for the reverse osmosis antiscalant category in/standards / International Certification. Its official name is the maximum dosage of various water supply products.
Only products with the / logo on the packaging can be used for drinking water treatment.
◇Product Dosing
Continuous dosing can greatly reduce scaling of reverse osmosis and nanofiltration membrane systems. It is recommended to operate at the highest frequency of the metering pump and adjust the dose by adjusting the stroke of the pump to effectively protect the film system.
The preferred solution is to use a closed feeding system to add pure fluid to avoid contamination from foreign impurities (a closed feeding system means that the fluid flows directly from a closed storage container into the treatment medium without being exposed to the atmosphere but is usually discharged The gas or pressure safety device is still open to the atmosphere).
(Only) Reverse osmosis effluent can be used for dilution and the following requirements should be followed:
. Use permeate water for dilution.
. Re-prepare the antiscalant solution every - days.
. Check the antiscalant daily dosage storage container before refilling the solution. If necessary, clean the storage container before adding.
. Dilution ratios of up to 100 times are usually used. If a higher dilution ratio is used, special attention should be paid to the state (cleanliness) of the antiscalant storage container and the solution should be prepared again every one day.
. Can be added to the diluent to increase the value to - It is especially recommended to use it in warmer environmental conditions to prevent the growth of microorganisms.
The dosage depends on the chemical properties of the feed water, membrane type and system operating parameters (such as recovery rate, temperature and pressure, etc.). These parameters determine the fouling species that may cause membrane module fouling. It is recommended to use special antiscalant calculation software to select the optimal dosage. This software can select the appropriate antiscalant and calculate the appropriate dosage based on the design and operation of the r system and the chemical characteristics of the inlet and concentrated water ends. The software is easy to use and automatically calculates various results.
◇Storage
The maximum storage temperature is (
℃).