Year1
- 型号：
- TN6211
- 规格：
- 250g/瓶
- 包装：
- 12瓶/箱
1. Product introduction
/ is a single-component UV curing glue. This series of products is mainly used for general-purpose thermoplastics in large, medium and small areas of projection curtain walls. Material film bonding. This series of products has low colloid odor, high bonding strength, good flexibility of the cured adhesive layer, high impact resistance, excellent aging resistance, water resistance and cold and heat resistance, and small volume shrinkage of the cured adhesive layer.
2. Product Features
Low viscosity, easy for construction and gluing.
, high colloid bonding strength after curing.
, has good flexibility, vibration resistance and good stability.
, complies with the company's R environmental protection specifications (tested for halogen-free components).
3. Technical parameters
Product name
Appearance transparent liquid Transparent liquid
Viscosity (.,℃)-
Fixed time (,℃)
Curing energy (,)
Tensile strength ()
Hardness (r)~
Elongation at break (%)
Dielectric constant/..
Dielectric loss/ ..
Dielectric strength/.
Surface resistivity/&;.&;.&;
Volume resistivity/&;.&;.&;
Remarks:< br/> Emphasis on the bonding of materials to soft materials
Emphasis on the bonding of glass materials to soft materials
Note: The above data are measured after metal halide lamp, wavelength accumulation energy/curing.
4. Operation process
Try to ensure that the gluing and film working space is closed, dry, and dust-free. If conditions permit, it can be equipped with an exhaust and ventilation chimney.
. Clean the material bonding surface (or glass material bonding surface) and the soft imaging film bonding surface from dust and moisture.
Place the clean material (or glass material) horizontally on the work surface.
. Apply the glue evenly in parallel lines to the material bonding surface (or glass material bonding surface) on the work surface, then flatly fit the soft bonding surface to one end of the material bonding surface and slowly fit it. Until the bonding is completed, the raised bubbles must be pushed out flatly.
. Push the movable curing device to the work surface and cure in sections until complete.
After solidification, it can be completely cooled before entering the mobile installation process.
5. Packaging Specifications
Gram, gram black plastic bottle packaging.
6. Storage and transportation
It needs to be sealed and stored in a dry place away from light and heat. The storage period is years (℃);
It can be transported and stored as non-dangerous goods.
WhatsApp
