Mobile phone parts fixing UV adhesive TNU6221

型号：

TNU6221

规格：

1KG/瓶

包装：

12瓶/箱

Mobile phone parts fixing glue Tiannuo
Product applicable objects:
It is a single-component UV curing glue for bonding between plastics and metals. It is mainly used to fix electronic parts. Mobile phone parts are fixed and assembled. Camera parts are fixed and connected to electronics. It is called assembling crafts, decoration, toys, production and assembly, etc. B, etc. are typical adhered plastics, stainless steel, aluminum, iron, copper, etc. are typical adhered metals.
Product Performance Characteristics
. Suitable for bonding and fixing in large and small areas. The speed is fast and the ideal bonding strength can be achieved in seconds.
.Adhesive force, long-lasting adhesion and high bonding strength.
.Excellent elongation and shock resistance without degumming or cracking after high and low temperature cycle testing.
.Waterproof, moisture-resistant, aging-resistant and excellent in long-term non-yellowing and whitening.
.High-quality imported materials comply with R and halogen-free environmental standards.
Product selection parameters
Product model
Bonding material plastic/metal
Appearance colorless and transparent
Viscosity.℃～
Curing energy/
Bonding strength
Hardness
Elongation
Temperature range~+
Shelf life in years
Specifications/
How to use the product:
In Before dispensing glue, be sure to clean the material to be glued so that its surface is dry and clean.
After completing the first step, pour the glue evenly onto one of the adhered materials. Place the other material gently on the glue to fit it together. Please squeeze hard to expel the bubbles and make the glue flow level. Make sure that the bonding parts are covered with glue and then fix the position.
Use a cloth or paper towel to wipe away any excess glue that has spilled around the material. Try not to expose the glue to UV rays before this step. Do not use a wet cloth or wet paper liquid (such as glass water, water, alcohol, and other solvents) to wipe away glue spillage around the material before the glue is completely cured.
Use ultraviolet light with a wavelength of ~ nanometers to illuminate until the glue layer has been fully cured. When irradiating, keep the UV lamp as close to the glue as possible to speed up the curing speed.
After curing by UV irradiation. If there is still glue overflow around the plastic, you can use a blade to scrape it off.