Professional sales of Jiangsu JS waterproof coating

Introduction to materials
Composite waterproof coating is a two-component waterproof material made of organic liquid materials and inorganic powders by introducing advanced technology and key raw materials.
Two main features
The wet surface construction coating is tough and high-strength.
Adding pigments can make a colorful decorative layer.
Non-toxic and odorless, it can be used for waterproofing of edible pools.
It is suitable for waterproofing the sloped roofs of exterior walls with facing materials. The construction on the inclined surface of the facade and the top surface can be firmly bonded with various outer materials such as base surface and facing bricks, roof tiles, cement mortar and so on.
High temperature resistance, especially suitable for waterproofing roads and bridges.
By adjusting the mix ratio, tile bonding materials and sealing materials can be made.
Three scopes of application
Roof waterproofing of industrial and civil buildings.
Waterproof and moisture-proof project for bathroom, bathroom and kitchen.
Waterproofing of walls, basements, swimming pool tanks, etc.
This waterproof coating is divided into type I and type II, and their usage is different.
① Type I is mainly used for parts with large deformation such as roofs, basements, etc.
② Type II is mainly used for parts with smaller deformation such as exterior wall toilets and bathrooms.
Four technical indicators implementation standards/
Technical indicators of No. 1 project
Type
Solid content,
Surface drying time
Solid drying time
Stretching Strengthbr/> Elongation at break
Low temperature flexibility, ф rod ℃, no cracks
Impermeable Water permeable Impermeable
Impermeability
Five construction methods selection
Construction method Ⅰ Undercoat and top coat of base layer
Construction method Ⅱ Undercoat and middle coat and top coating of base layer
Construction method Ⅲ Undercoat and non-woven fabric layer and middle coating Coating
Six construction points
The base surface must be flat, firm, clean, free of water and leakage. The uneven and cracked areas must be leveled first, and the yin and yang angles should be made into arc angles
Accurate ingredients. For the convenience of users, the company has packaged it strictly according to the proportion requirements. When using, you only need to slowly add the powder to the corresponding liquid while stirring, and fully stir until a uniform, fine and lump-free mixture is obtained.
Coating essentials
① Apply with a roller or brush, and complete layer by layer according to the order of the selected construction method
② If there is precipitation in the paint, especially the primer, stir it evenly at any time
/> ③ The coating should be as uniform as possible without local deposition
④ The time interval between each layer shall be based on the time when the previous layer of coating is dry and non-sticky
⑤ The non-woven lower coating in method III The fabric layer and the middle coating must be applied continuously
Seven precautions
Do not apply below ℃ or in the rain, and do not apply in a particularly humid and non-ventilated environment.
8. Storage, transportation and packaging
Liquid materials must be stored in a cool place above ℃, and powder materials should be placed in a dry place. Pay attention to moisture and sun protection. The shelf life is one month
The powder of this product is packed in composite bags, and the liquid is packed in plastic barrels