SikaGrout-ConstructionSika grouting material

Sika grouting material
Application of Sika grouting material
☆ Grouting repair
☆ Horizontal reinforcement anchoring
☆ Grouting for caves, trenches and recesses
☆ Equipment installation grouting
☆ Column volume, equipment, chassis foundation grouting



Advantages of Sika grouting material
☆ Good flow performance< br/> ☆ Shrinkage compensation
☆ Fast strength growth
☆ Non-toxic, non-corrosive
☆ Does not contain iron ions and chlorine salts
☆ Long operating time
☆ The slurry is simple to mix and construct
☆ The construction is simple, just add water and stir as required on site before use
☆ Pre-mixed packaging to avoid product performance fluctuations caused by on-site preparation



Sika grouting material product parameters


Packaging



Bag

Appearance/
Color

Gray powder

Dry powder capacity




/> Mixing water amount

Liters
Water/
Kg (bag)

Mortar density

br/>Kg /
L

Shelf life

Original sealed storage
months

Testing and certification/
Standards


Cement-based grouting material

Fluidity test


Initial fluidity
,
minutes Fluidity retention value


Compressive strength
(according to /
)



days
/>



Tian




Tian






Instructions for use

Amount of water to add
Liters
Water/kg kg
(bag)

Base preparation
The concrete surface must be dry, dense, free of oil, cement laitance and any particles that are not conducive to bonding. The surface of metal (steel and iron plates) must be free of scale, rust and oil. The absorbent base layer needs to be saturated with water.

Mix
Mix
Add water to each
/
bag
to achieve desired consistency, using an electric mixer on low speed (speed No more than
turn/
minutes until evenly mixed.

Construction

It is recommended that experienced or trained construction personnel complete this work. And reasonable on-site arrangements are required. Pour the mixed grouting material into the foundation. The grouting material can only be poured from one side so that the gas can escape freely. When constructing the base plate, there needs to be sufficient pressure so that the grouting material can Full flow. Grouting must be completed within minutes after mixing the material, and the construction must be continuous. In the case of more difficult pouring, guide strips can be used, but vibration equipment is not suitable.

Cleaning of tools
After use, clean tools and equipment with water immediately. Hardened and cured materials can only be removed mechanically.

Protective measures
During operation Wear protective gloves and goggles.

Toxicity
Toxicity
For the latest information, please consult the Material Safety Data Sheet provided by
in accordance with national requirements.


Notes
Any technical parameters in the product manual are based on experimental tests, and the test results may vary under different circumstances.
The handling of raw material residues must be in accordance with local regulations The requirements of regulations are implemented. With the consent of the local government, the completely solidified raw materials can be disposed of as ordinary garbage.