Bucket elevator

TD：

TG

series bucket elevators have the characteristics of small footprint, high lifting height, large conveying capacity, low power consumption and good sealing performance. It is suitable for vertical conveying equipment of granular and powdery materials in the grain, food, feed, mining and other industries. Troubleshooting methods for bucket elevator faults
The tailstock tension wheel of the belt deviation machine is not leveled and the tensioning screw is not adjusted
The hopper hits the casing and the hopper belt is not tensioned and the tensioning screw is not adjusted
The return flow is too large. The position of the unloading adjusting plate of the machine head is incorrect. Adjust the adjusting plate so that the adjusting plate is connected as far as possible into the reducer at the mouth of the hopper. Or the temperature rise of the bearing is too high. There is dirt inside. Improper installation. Remove the dirt and recalibrate the installation.
Bucket elevator installation steps instructions
When installing the elevator, the base should be fixed first, and the base should be fixed on a reliable foundation, then connect the barrel to the base in sequence, and finally connect the machine head and Install the reduction motor.
After the whole machine is installed and straightened, the barrel must be fixed to the floor where it passes through the floor. If there is any attachment, a bracket should be installed to support the casing to prevent the entire machine from tilting and shifting.
A sealing gasket must be inserted into the barrel connection to ensure sealing.
The hopper of the elevator is installed on the hopper belt as required, and the two ends of the hopper belt with the hopper installed are put in from the machine head respectively. Go around the head wheel and bottom wheel and connect them at the control hole. When installing the hopper belt. The bottom wheel should be adjusted to its highest position.
Correct the head wheel shaft to level, and make the head wheel shaft and tail wheel shaft in the same vertical plane.
Bucket elevators are vertical conveying equipment. The central line of the barrel of the head wheel and bottom wheel should be on the same vertical line. The deviation should not exceed millimeters per meter of length, and the accumulated deviation should not exceed millimeters.
The hopper is installed in the elevator and should not be deflected to cause collision with the casing.
The tensioning device should ensure that the hopper belt has an average tension necessary for normal operation.
After the hoist is installed, lubricating oil should be added to each lubricating part and a no-load test run is carried out. Only after the no-load test run is normal can the load test run and put into production be carried out.