First-level agent for VGM reducer in Guangdong area

产地：

台湾

型号：

MF090L2-9-19-70

平均使用寿命：

20000小时

Taiwan original Jusheng reducer reducer, Guangdong area first-class agent Taiwan reducer Jusheng reducer original reducer Jusheng reducer first-class agent Taiwan original reducer Jusheng reducer agent Taiwan Jusheng reducer Jusheng reducer Taiwan The first-level agent of the original Jusheng reducer in Guangdong is looking for regional dealers to provide high-quality, cost-effective reducer selection technical support and long-term after-sales service. Shenzhen Zhongzheng Precision Electromechanical is the first choice for purchasing Taiwanese original reducers.
- -
.
Taiwan original reducer installation steps:

Step 1:
Check whether the specifications of the motor and reducer are correct and whether the interface is consistent .
Clean the surface of the connection interface between the motor and the Jusheng reducer to remove oil dirt and impurities.

Step 2:
Adjust the position of the original Jusheng reducer input shaft locking screw to align with the side hole of the reducer input cover.
If there is a keyway on the motor shaft, remove the fixed key. If there is a balance weight key, insert it into the keyway.
Check the diameter of the motor shaft and add a bushing to the input shaft hole of the reducer if necessary.
Install the motor onto the Jusheng reducer.
Use a hexagonal wrench to tighten the locking screws at both ends of the input shaft of the reducer according to % of the recommended tightening torque value.

Step 3:
Place the motor vertically with the Taiwan original Jusheng reducer.
Use a hexagonal wrench to tighten the Jusheng reducer flange and motor flange using locking screws and washers in diagonal order according to % of the recommended tightening torque value. (The locking screws should be coated with screw anti-loosening agent in advance).
Use a torque wrench to tighten the reducer flange and motor flange using locking screws and washers in diagonal order according to % of the recommended tightening torque value.

Step 4:
Use a torque wrench to tighten the locking screws at both ends of the input shaft of the Taiwan original Jusheng reducer according to % of the recommended tightening torque value.

Taiwan Jusheng reducer is divided into seven series:

. Taiwan original Jusheng reducer series (round without flange)
． Taiwan original Jusheng reducer-series (round with flange)
． Taiwan original Jusheng reducer-series (square)
． Taiwan original Jusheng precision reducer-series (round with flange)
． Taiwan original Jusheng ultra-precision reducer-series (square)
． Taiwan original Jusheng right angle reducer series (ultra-precision shaft output type)
． Taiwan's original Jusheng right-angle reducer series (hollow shaft output, single-shaft output, dual-shaft output)
Jusheng reducer first-level agent in Guangdong (Shenzhen Zhongzheng Precision Mechanical and Electrical Co., Ltd.) specializes in providing: Jusheng reducer series Reducer - Series Jusheng Reducer - Series Taiwan Reducer - Series Jusheng Reducer - Series Right Angle Reducer Series Right Angle Reducer Series % original and authentic.