Manufacturer customized DDF large pulse bag dust collector equipment boiler dust collector

处理风量：

30000-90000m3/h

过滤风速：

0.5m/min

过滤面积：

1000㎡

< Welcome< Xianxian Yongsheng Environmental Protection Equipment Co., Ltd.< Our company is an entity processing and manufacturing enterprise. Dust collector equipment has been sold to all provinces and cities across the country. The company relies on a perfect after-sales system to survive and develop with integrity. Product quality is reliable< Dust collector< The steel plates and shapes used in manufacturing are all national standards and the thickness reaches the standard. The whole process is made and welded firmly. In the early stage, we can provide measurement services to design the dust removal equipment more accurately for you. If there are quality problems with the equipment in the later stage, our company can also send technicians to repair it (the whole process is free of charge). Any fees) If you need to understand and design The most important point for the dust collector is the exhaust The ash device must be able to discharge dust smoothly because this is related to the efficiency of the dust collector. The ash discharge system must maintain good sealing performance to prevent air leakage and reduced filtration efficiency caused by loose sealing.
When choosing an ash discharge device, you should clearly understand the nature of the dust to be filtered from the purchaser, dry dust or wet attached dust, whether it is corrosive, the interval for cleaning, the amount of dust generated, and the pressure of the air inlet inside the dust collector. Wait for parameters.
. A column should be installed above the ash discharge device to prevent the fallen dust from forming into lumps and sealing. At the same time, the sealing of the entire bag dust collector and the ash outlet should be ensured.
The dust output of the ash hopper ash discharge equipment is smaller than the conveying volume of the screw conveyor.
If you are using a dust discharge valve, a gravity flap valve, etc., you must install them vertically to ensure normal use.
The complete structure of the stand-alone dust collector equipment that our company specializes in includes the bag dust collector box, four-corner supports, exhaust fan, adjustable control system, filter bag, inspection door, rapping device, ash discharge hopper, The ash discharge system, dust cleaning system, injection system, air duct, etc. make up the lower ash hopper and the skeleton of the dust collector. The dust collector box includes the upper box and the lower box. The exhaust fan will be set inside the dust collector. The filter bag and the ash receiving hopper are also The dust collector frame is installed inside the lower ash hopper of the dust collector. The dust collector frame is inside the filter bag. The dust collector bag and the frame are suspended in the upper box. The working state is integrated, and there is a steel sealing ring on the top of the dust collector frame for tight sealing. The ash leakage rapping device will connect the frame of the dust collector and the motor. There will be an inspection door on the side of the lower ash hopper, through which you can enter the air inlet of the dust collector during maintenance. At the top of the upper box, there are finally the vibration motor, electromagnetic pulse valve, and cylinder. Connected to the control system.