Tongfeng new centrifugal oil filter manufacturer direct supply freezing point price free shipping collect

Tongfeng centrifugal oil filter operating instructions:
>. Turn on the power of the centrifugal oil filter and add it to the machine to squeeze the crude oil. The crude oil flows from the flow pipe of the oil hopper through the hollow shaft at the upper end of the centrifuge to the bottom of the drum. The small nylon disc on the small disc quickly and evenly distributes the crude oil to the inner wall of the drum. At this time, the strong centrifugal force generated by the high-speed rotating drum separates the solid-liquid with different mass and weight. After adding the crude oil, turn off the power within 1 minute. After the rotating drum gradually stops rotating, the pure oil flows out automatically to achieve the purpose of fine filtration. It only takes 1 minute to filter a kilogram of oil per hour.
>. Cleaning ① Cleaning the slag in the drum is to clean the slag once. Every time you clean the slag, you must clean the slag around the inner wall of the drum. Otherwise, the drum will be biased due to incomplete slag cleaning, which will cause it to be filtered again. Produces machine vibration. ② To clean the outer barrel, Tianqing opens the upper cover of the outer barrel and the upper cover of the inner barrel respectively, removes the small screw on the small disc in the middle of the bottom of the inner barrel, and then two people can lift the inner barrel vertically with their hands to clean it. After cleaning the bottom of the outer barrel, reinstall the inner barrel. Place the small disc and rubber ring at the bottom of the inner barrel (to prevent oil leakage and sealing effect). Then tighten the small screws (not too tight to prevent twisting) and close the upper cover of the inner barrel. The upper cover of the outer barrel can be turned on and used again. Be careful not to turn on the machine without installing each component. This will cause damage to the equipment and the manufacturer will void the warranty.
>. When using a centrifugal oil filter, the concrete foundation must be prefabricated and the anchor bolts should be embedded at a distance of three anchor bolt holes. The prefabricated concrete surface should be horizontal and the center of the equipment footing should be added. Rubber anti-vibration pad.