The vertical dirt remover has three structures: Y type, basket type and backwash type.

『Product Description』 (,,) The vertical dirt remover has three structures: type, basket type and backwash. The medium enters the cylinder from one side of the pipe and the other side is connected to the filter hole tube in the cylinder. The filter hole tube has many small hole composition. The impurity particles in the medium are filtered out by the holes, and the medium without impurity particles accumulated at the bottom of the cylinder flows out from the outlet of the filter hole. When discharging sewage, open the sewage valve to discharge impurity particles. It is recommended to install a valve between the inlet of the sewage remover and the pipeline. When discharging sewage, close it and open the sewage valve to allow the medium to flow out of the filter mesh holes for flushing.
『Design Features』
The equipment is simple, reliable, convenient and widely applicable.
『Application fields』
. Weak corrosive materials in chemical and petroleum production such as ammonia, oil, hydrocarbons, etc.
. Corrosive materials in chemical production such as carbonic acid, acetic acid, esters Acid, etc.
. Low-temperature materials in refrigeration such as: liquid ammonia, liquid oxygen and various refrigerants
. Materials with hygienic requirements in food and pharmaceutical production such as: beer, beverages, dairy products, grain slurry Medical supplies, etc.
. Power plants, boiler equipment such as: water, gas, steam, liquid, etc.
. HVAC, liquefied gas stations: such as: hot water, heating, gas, liquefied gas, coal gas, natural gas, etc.
.Steel and metallurgical equipment: hydrogen, oxygen, etc.
"Please inform us when ordering"
Caliber d temperature d pressure d medium d filtration accuracy d connection method d material d flow and other parameters so that we can More accurate service.
『Corporate Philosophy』
Market the world with brand, create the future with technology, and win customers with service. Our goal
『General principles for filter selection』
, Inlet and outlet diameter:
In principle, the inlet and outlet diameter of the filter should not be smaller than the inlet diameter of the matching pump, which is generally consistent with the diameter of the inlet pipeline.
, Nominal pressure:
Determine the pressure level of the filter according to the highest possible pressure in the filter pipeline.
Selection of the number of holes:
The main consideration is that the particle size of the impurities to be intercepted is determined according to the process requirements of the media process. Check the filter specifications in the table below for the particle sizes that wire mesh of various specifications can intercept.