Year1
Two application areas
Particularly suitable for aluminum alloy surfaces and joint surfaces that are relatively displaced due to vibration stress and temperature changes. It can also be used as a gasket coating, such as pump transmission bodies, axles, etc., with a maximum sealing gap of for.
Three product performance indicators
Indicators
Appearance
Red paste, no visible impurities
/>
Density/
Maximum filling gap
Operating temperature °C
~
Reach fluid sealing speed
Faster
Maximum sealing pressure
The relationship between curing speed and substrate
The curing speed is related to the substrate used. The graph below shows the degree of cure versus time on different materials.
r//r/~_ __ />
The relationship between curing speed and sealing gap
The curing speed is related to sealing gap. The sealing gap depends on the type, quality and size of the parts to be sealed. The figure below shows the variation of intensity with time under different gaps.
r//r/~_ __ />
The relationship between curing speed and temperature
The curing speed is related to temperature. The graph below shows the degree of cure as a function of time at different temperatures.
r//r/~_ __ />
The relationship between curing speed and accelerator
When the curing speed is too slow or the bonding gap is large, surface treatment with accelerator can speed up the curing speed. . The graph below shows the strength as a function of time with and without accelerator.
r//r/~_ __ />
Hot Strength
The graph below shows the strength tested at different temperatures.
r//r/~_ __ />
Heat Aging Resistance
The figure below shows the relationship between the strength and time after aging in different temperature environments, tested at room temperature and ° C.
r//r/~_ __ />
Media resistance
The following table shows the strength retention rate under specific conditions tested at room temperature and ℃.
Strength retention
Environment
Environment
℃
Engine oil
Gasoline
Water glycol
Four General Information
This product is not recommended for use in pure oxygen or oxygen-enriched systems and should not be selected for use with chlorine or other strongly oxidizing substances. of sealant
glue.
When using cleaning fluids to clean substrate surfaces, it is important to check the compatibility of the cleaning fluid with the adhesive. In some cases, these cleaning fluids can affect the cure and performance of the adhesive.
This product is generally not recommended for use on plastics, especially thermoplastics, as it may cause them to crack. Users are advised to confirm the compatibility of the product with the adhesive before use.
Five usage methods
Remove oil, dust and rust from the adhered surface, clean it with B cleaning agent and dry it.
Open the cap of the glue bottle and squeeze out the glue onto the cleaned surface. The glue should be applied sufficiently to ensure that there is no shortage of glue.
Tighten the thread. The position can be adjusted before initial tightening. It is not advisable to loosen the thread after initial tightening.
Tighten the thread in place and leave it in the air to solidify naturally. Can provide an instant seal, curing is required to achieve maximum sealing pressure.
Six Precautions
Metal oil and debris must not be mixed into the bottle.
When the temperature is below ℃, the curing speed and strength can be increased by using B accelerator.
Wear rubber gloves for long-term contact. If it accidentally enters the mouth or eyes, please wash it with clean water immediately and seek medical treatment.
Seven packages for storage and transportation
/ branch, branch/box/tube, branch/box.
Store in a cool and dark place, below ℃, the glue storage period is one year.
This product is a non-dangerous product and is transported as a general chemical.
8 Please read carefully for more information
The data in this article are for reference only and are considered reliable. However, because conditions and methods of use of our products are beyond our control, this information should not substitute for customer's testing to ensure that our products are safe, effective and fully satisfactory for their intended end use. If you want to know more safety information, please check the product safety data or ask the relevant sales personnel.
WhatsApp
