Acrylic waterproof coating

1. Product introduction Acrylic waterproof coating (series of water-based color multi-functional waterproof coatings) is a single-component, water-based acrylic waterproof coating. This coating uses pure acrylic emulsion and polyacrylic acid emulsion as base materials, and is mixed with a variety of additives and inorganic fillers. After coating, a tough, elastic waterproof membrane with strong adhesion can be formed, which together with the base layer forms a complete waterproofing system combining rigidity and softness to adapt to various deformations of the structure and achieve long-term waterproofing and impermeability. This product can be made into various colors as needed.
2. Product Features
Can be applied directly on wet or dry substrates of various materials.
The coating is tough and strong, water-resistant, resistant to high and low temperatures, and has good aging resistance. Especially in terms of UV resistance, it is better than general waterproof products.
, strong adhesion, good extensibility, optional color.
, single component, simple construction and short construction period.
, non-toxic and odorless, it is a substitute for solvent-based waterproof coatings such as polyurethane coatings and paints that are currently commonly used.
, add various colors, can be used as decorative waterproof coating.
3. Scope of application
This product is widely used for waterproofing and moisture-proofing of cast-in-place concrete roofs, walls, asbestos cement tile roofs, interiors, bathrooms, warehouses, etc., as well as for renovation and leak repair of old building surfaces. It can also be used as a protective layer for other waterproof layers.
4. Implementation Standards for Main Technical Indicators/"Polymer Emulsion Architectural Waterproof Coating"
Technical Indicators
Type I Technical Indicators Type II
Solid Content

Tack drying time

Solid drying time

Tensile strength

Elongation at break

Low temperature flexibility (rod winding)
℃No cracks
℃No cracks
Water impermeability
Waterproof
Waterproof
5. Construction method
Base layer treatment The base layer is firm , strong, smooth, no sharp corners, no rust, oil stains and obvious water stains. The inner and outer angles should be made into arc shapes with cement mortar or sealing paste. The diameter of the inner angle should be larger than that of the outer angle, and the diameter of the outer angle should be larger than that of the outer angle. Cracks in the base layer and grooves left by pipe roots should be filled with sealing materials.
. Base treatment agent. In order to improve the adhesion, base treatment agent should generally be applied. The base treatment agent can be prepared on site by diluting the waterproof coating with water. It is recommended to add the appropriate amount of water. For special base layers, special supporting base treatment agents can be used. The amount of base treatment agent is about m2.
The thick waterproof coating film should be applied in ~ times to form a film, and the last coat can be applied only after each coat is dry (generally, the painting directions are perpendicular to each other at intervals of ~ hours. If additional carcass reinforcement materials are required, , the carcass material should be flat, wrinkle-free and soaked. The thickness of the coating film under the carcass should be no less than that of the upper coating film. The dosage and thickness of the carcass should be no less than
. The dosage and thickness should be ㎡~㎡. Thick coatings require coating The quantity is approximately ㎡.
6. Packaging, transportation and storage
The product is placed in a clean, dry, sealed plastic barrel, with a packaging capacity of /barrel, /barrel.
Transport press Non-dangerous goods requirements. During transportation, prevent rain, exposure, squeezing, collision, and inversion, and keep the packaging intact.
The product should be stored in a ventilated, dry, and cool place to prevent direct sunlight. The storage temperature should not be Should be lower than ℃. Validity year