Bolong water does not leak

1. Product Features: The watertight sealant has the advantages of being moisture-proof and impermeable, quick to plug leaks, firmly bonded, and non-toxic and harmless. The material is susceptible to moisture and should be sealed and stored in a dry place.
Second scope of use
This watertight seal is suitable for use on seepage surfaces and leaky openings. For non-permeable surfaces, it is best to use slow-setting water to prevent leakage. For large-area waterproofing, it is advisable to use the composite waterproof coating produced by our company to form an elastic waterproof layer.
Three Materials Preparation
The scraping material is based on powder and water. It is best to use a mixer to stir for a few minutes to form a uniform putty, and the material does not contain hard lumps or cornstarch.
Knead the leak-proofing material into a ball with powdered water. In order to ensure the quick setting of this material, when the ambient temperature is lower than ℃, use warm water of about ℃ for seasoning.
Four Construction Operations
Dry the base surface with a dry cloth before applying water seepage materials and quickly apply materials.
Use a trowel to apply the first layer of material first. If there is water leakage, leave it alone
After the coating hardens, press it with your hands without leaving fingerprints and spray it with water but there should be no accumulation of water
Use a scraper again Or if there is still water seepage in the second layer of material on the trowel, use another layer of material to block it until no leakage occurs.
When loading, use a little force and go back and forth several times to make it dense, and pay attention to the overlap. The dosage for each layer is approximately /. The total dosage is approximately /.
According to the shape of the leaking hole, knead the leak-stopping material into a ball slightly smaller than the size of the hole. Leave it for a few minutes until it feels hard when you pinch it with your hands. Then stuff it into the leaking hole, and use a wooden stick to squeeze and lightly smash it towards the leaking hole. Squeeze tightly around to stop leakage instantly, then apply a layer of scraping material outside and around the opening. Before plugging the leak, it is best to waterproof the surrounding areas that may leak, and then plug the leak after the waterproof layer hardens, otherwise water may be squeezed out from the surrounding area.
Five surface treatment
The base surface of the permeable surface must be fully moistened until it is saturated and no longer absorbs water, and it must be clean, firm and flat but not too smooth.
For the water leakage, use a chisel or impact drill to drill a groove or hole to a certain depth of about 100 meters and as large as possible on the inside and as small as possible on the outside. The hole should be as small as possible, but new growth must be seen, and then rinsed clean.
Six Moisturizing and Maintenance
After the coating hardens, perform moisturizing and maintenance immediately to prevent powdering. The maintenance method can be spraying water, covering the wet object and applying maintenance fluid, etc. Care should be taken during the first curing to avoid damaging the coating. The curing lasts for several days. It can be cured naturally in humid places such as basements with water seepage.
Seven Precautions
If the waterproof layer still leaks water over a large area after construction, it must be moisture condensation, which will disappear after a few days of drying. Special reminder that construction is not suitable on rainy days!