JS waterproof coating

Composite waterproof coating is a two-component waterproof material made of organic liquid materials and inorganic powders by introducing advanced technology and key raw materials. Two main features
The wet surface construction coating is tough and high-strength.
Add pigments to create a colorful decorative layer.
Non-toxic and odorless, it can be used for waterproofing of edible pools.
It is suitable for waterproofing the sloped roofs of exterior walls with facing materials. The construction on the facade slopes and top surfaces can be firmly bonded to the base surface and facing bricks, roof tiles, cement mortar and other outer layer materials.
High temperature resistance, especially suitable for waterproofing roads and bridges.
Adjust the mix ratio to make ceramic tile bonding materials and sealing materials.
Three Scope of Application
Roof waterproofing of industrial and civil buildings.
Waterproof and moisture-proof project in toilet, bathroom and kitchen.
Waterproofing of walls, basements, swimming pool tanks, etc.
This waterproof coating is divided into type I and type II, and their usage is different.
① Type I is mainly used in parts with large deformation, such as roofs and basements.
②Type II is mainly used in parts with smaller deformation such as exterior wall toilets and bathrooms.
Four Technical Indicators Implementation Standards/
No. Project Technical Indicators
Type
Solid content,
Explicit drying time
Practical drying time
Stretching Strengthbr/>Elongation at break
Low temperature flexibility, ф rod ℃, no cracks
Impermeable Water permeable Impermeable
Impermeability
Five construction method selection
Construction method Ⅰ Base layer, undercoat, and upper coating
Processing method Ⅱ Basecoat, undercoat, middle coat, and topcoat
Construction method Ⅲ Baseboard, undercoat, and non-woven fabric layer, middle coating Coating
Six construction points
The base surface must be flat, firm, clean, free of open water and no leakage. The uneven and cracked areas must be leveled first, and the yin and yang angles should be made into arc angles
Accurate ingredients. For the convenience of users, the company has packaged it strictly according to the proportion requirements. When using, you only need to slowly add the powder to the corresponding liquid while stirring, and fully stir until a uniform, fine and lump-free mixture is obtained.
Coating essentials
① Apply with a roller or brush, and complete layer by layer according to the order of the selected construction method
② If there is precipitation in the paint, especially the primer, stir it evenly at any time
③ The coating should be as uniform as possible without local deposition
④ The time interval between each layer shall be based on the previous layer of coating drying and not sticking to the hand
⑤ The non-woven lower layer in construction method III The fabric layer and the middle coating must be applied continuously
Seven Precautions
Do not apply below ℃ or in the rain, and do not apply in a particularly humid and non-ventilated environment.
8 Storage, transportation and packaging
Liquid materials must be stored in a cool place above ℃, and powder materials should be placed in a dry place. Pay attention to moisture and sun protection. The shelf life is one month
The powder of this product is packed in composite bags, and the liquid is packed in plastic barrels