Year1
- 规格：
- 公斤
- 包装：
- 罐装
< Overview
< This product is a modified epoxy resin adhesive, two-component, rapid curing at room temperature, bonding High strength, excellent temperature resistance, strong adhesion, super structural performance, and easy operation.
< Scope of application
< Suitable for self-adhesion and mutual adhesion of silicate, alumina series ceramics, enamel, etc. working under high temperature conditions, as well as high-temperature surface coating, bonding, filling, sealing, and plugging Leak and crack repair.
Performance
Features
Points
< Appearance: Components are light-colored viscous liquid, no Solid particles. Component B is a light yellow mixed viscous liquid.
The curing speed is fast. At ℃, it will start to cure in an hour and approach the maximum bonding strength in an hour.
Heat in an oven at ℃ for complete curing in minutes.
High bonding strength, good toughness, good durability, and excellent UV resistance.
It has good temperature resistance and can adapt to a wide temperature range. It still has good bonding effect at higher temperatures after bonding.
The glue has moderate viscosity, no bubbles, good leveling performance, and good surface finish after curing.
The bonding surface does not need strict treatment, and the two components are prepared in proportion, making it easy to use.
Excellent media resistance, resistant to oil, water, acid, kerosene, ethanol, alkali, heterocyclic hydrocarbons, nuclear radiation, etc.
Safety and toxicity characteristics: It has a very slight odor, no inhalation hazard, and is actually non-toxic after curing.
The storage stability is good, and the storage period is months.
The main technical performance indicators are as follows:
Temperature resistance range: +℃
Bonding strength: normal temperature: tensile strength shear strength
℃: tensile strength
< Instructions for use
<: Remove rust, decontamination and clean the adherends.
, will, B component press:. ． The proportion is fully mixed and the glue is applied evenly.
. Apply the prepared glue to the surface of the adherend, close it, compact it, and let it sit for ~ an hour.
If the coated ceramic surface needs to be shaped, it is necessary to wait for the glue to be in the initial curing time after the glue is coated on the material, and then hot press or cold press the shape.
Pay attention to ventilation in the operating environment.
If the glue touches the skin, rinse it with soapy water in time.
Unused glue should be covered and placed in a cool and ventilated place.
WhatsApp
